Roll Marking

Available in hand-, air- or hydraulic-operated configuration, designed for marking both flat and cylindrical components. Using roller fixtures, the work piece rotates about its own axis, allowing the inscription length to equal the carriage stroke. Marking thin walled tubular components the work piece supported on a needle bearing mandrel, marking flat components with a gear controlled marking die. The work pieces remains stationary.

Machinery Selection

Manuel operated MARKATOR MV 41 M
suitable for diameters up to 55 mm

Manuel operated MARKATOR MV 70 M 1
suitable for diameters up to 90 mm

Manuel operated MARKATOR MV 70 M 2
suitable for diameters up to 150 mm

Pneumatic operatedMARKATOR MV 70 P 1
suitable for diameters up to 50 mm

Pneumatic operatedMARKATOR MV 70 P 2
suitable for diameters up to 150 mm


Hydraulic operated MARKATOR MV 150 EH
suitable for diameters up to 400 mm

Roller Fixtures

Twin roller fixtures are designed to support solid or thick walled round work pieces. Adjustable roller fixtures are also available. Fixtures with free running mandrels allow thin walled components to be supported internally to prevent friction and distortion under the marking load. The mandrels are quickly interchangeable to accept a range of bore sizes.